Vista Ademco -10SE User's Guide download pdf (Page 57)

– 57 –

Testing The System (cont’d)

Testing Your System

1. Open and close each protected door and window in turn and listen

for three beeps. The identification of each faulted protection point

should appear on the display.

2. Walk in front of any interior motion detectors (if used) and listen

for three beeps as movement is detected. The identification of the

detector should appear on the display when it is activated.

3. Follow the manufacturer's instructions to test all smoke detectors

to ensure that all are functioning properly. The identification of

each detector (or the zone number of the zone assigned to the

detector) should appear on the display when each is activated.

4. When all protection points have been checked, there should be no

zone identification numbers displayed. If a problem is experienced

with any protection point (no confirming sounds, no display),

CALL FOR SERVICE IMMEDIATELY.

5. Turn off Test mode by entering the security code and pressing the

OFF key.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 79 80

No comments

Vista Ademco -10SE User's Guide Page 57