Vista Ademco -10SE User's Guide download pdf (Page 37)

– 37 –

Using The Keyswitch

General

Your system may be equipped with a keyswitch for use when arming

and disarming a partition. A red and green light on the keyswitch

plate indicate the status of your system as follows:

Green Light: Lights when the system is disarmed and ready to

be armed (no open zones). If the system is disarmed

and the green light is off, it indicates the system is

not ready (one or more zones are open).

Red Light: Lights when system is armed or memory of alarm

exists.

Lit Steady: Partition is armed in AWAY mode.

Slow Flashing: Partition is armed in STAY mode.

Rapid Flashing: Memory of alarm, indicating an alarm has occurred .

Arming

To arm in the AWAY mode, turn

the key to the right for 1/2 second

and release. Keypads will beep twice

and the red light will stay on steady.

To arm in the STAY mode, turn

the key to the right and hold for

longer than 3 seconds, then release.

Keypads will beep three times and

the red light will flash slowly.

Disarming

To disarm the partition, turn the

key to the right and release. If an

alarm has occurred, the red light

will be flashing rapidly (memory of

alarm).

GREEN

RED

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 79 80

No comments

Vista Ademco -10SE User's Guide Page 37