Vista Ademco -10SE User's Guide download pdf (Page 14)

– 14 –

Entry/Exit Delays

General Information

Your system has preset time delays, known as exit delay and entry

delay. Whenever you arm your system, exit delay gives you time to

leave through the designated exit door without setting off an alarm.

Exit delay begins immediately after entering any arming command,

and applies to all modes of arming protection. If programmed, a slow

beeping will sound throughout the exit delay period.

Entry Delay gives you time to disarm the system when you reenter

through the designated entrance door. But the system must be

disarmed before the entry delay period ends, or an alarm will occur.

The keypad will beep during the entry delay period, reminding you to

disarm the system. You can also arm the system with no entry delay

at all by using either INSTANT or MAXIMUM arming modes. These

modes provide greater security while on the premises or while away

for extended periods of time. See your installer for your delay times.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 79 80

No comments

Vista Ademco -10SE User's Guide Page 14